2024年4月26日发(作者：黑莓z30和z10哪个好)

the professional’s choice

Nova-Strobe Battery Replacement

for models: Nova-Strobe BBX, Nova-Strobe DBX, and Phaser Strobe PBX, Vibration Strobe VBX

Before you open the case, know that during the reassembly there are multiple points that

need to align correctly to close the case securely.

Some of them include:

•

•

•

•

•

•

•

Display board sits in groove

DC Connector spans both case halves

Mounting T-nut sits in slot as shown

Lanyard knot surrounds screw standoff and protrudes through the notch in the case

Trigger sits in case brackets with wires tucked out of the way

PCB aligns in a retaining groove

Battery holders (2) nests in brackets, there is a right and wrong way to insert them

Taking the unit apart is the easy part . . .

To do this, [A] remove the lens by

separating the two tabs that hold

it in place. Put a piece of tape on

the side of the lens that faces out

so it can be installed correctly. Slide

the refl ector [B] and lamp out as

detailed in the Lamp Replacement

section of your manual. This will

expose four screws [C] that must

be removed so the refl ector hous-

ing can be removed from the main

body. There are then four additional

screws [D1] & [D2] in the case

halves opposite the input and

output jacks that must be removed.

The case halves can now be separated,

exposing the batteries. They should

be sent to a recycling center or

returned to Monarch for disposal.

[C]

[B]

[A]

[D1]

[D2]

1.800.561.8187

*******************

[D1]

Placing the left side of the case

on a roll of tape or other lift

will prevent the speed knob

from pushing the PCB out of

the retaining slots when

aligning all.

[D2]

[D1]

Replace the battery.

Ensure that the replacement battery is plugged

into the PCB fi rmly. Carefully place the right half

(1055-4241-111) onto the left (1055-4242-111).

Align the display board [F], battery [G], and main

PCB [H] into the slots provided in the case. Align

the display and battery fi rst, then from the front

of the unit, guide the PC Board into the retaining

slots with a wooden stick. Ensure the trigger wires

[I]and DC Jack [J] are properly in place.

Fasten both halves using two 2” self tapping

screws [D] (1053-3328-001) through the body of

the right half. Do not over tighten screws.

Gently pry apart case halves at the base of the

handle and insert tee nut [K] (1053-0270-001)

into slot in left handle.

Slip knotted end of wrist strap [L] (3051-2000-

015)over left half handle standoff and through

slot provided.

Carefully press case handles together, ensuring

[F]

the wrist strap fi ts into the notch provided and no

wires are pinched between the case halves.

[J]

Re-attach the refl ector housing.

Do not over tighten screws [C], [D1], [D2].

[I]

[K]

Top half of the

Battery Holder sits

in the right side case.

Note the position of

the cradle guides

[G]

[H]

[L]

Monarch Instrument © 2018

Nova-Strobe Battery Replacement 8/2018 v3.0

1.800.561.8187

*******************