2024年4月7日发(作者：)
multisim总线的建立方法
在NI Multisim中创建总线向量
Overview
Today’s engineers require sophisticated tools to match the increasing
complexity of their designs. Specifically, as pin counts and trace counts increase,
designers turn to buses to logically organize their connections.
Multisim delivers powerful bus-vector connectivity. Not only can you easily
draw buses with a few
clicks of the mouse, but you also have to intuitive methods for creating
connections both to and
among buses.
Additionally, buses can be linked across pages of complex designs or to the
inputs and outputs of Hierarchical Blocks and Subcircuits.
There are two bus wiring modes: busline mode and net name mode. In net
name mode, buslines take on the name of the nets connected to them, whereas
in busline mode, buslines have unique names.
These tips apply only to busline mode, which is the default mode. To switch
between modes, use the Wiring tab of the Sheet Properties dialog box.
Once a bus has been created, you can add new buslines and tap into them as
many times as you need to manually. Additionally, you can add new buslines
automatically using the Bus Vector
Connect tool, and automatically tap into them as many times as you need to
using the same tool.
Table of Contents
1. Placing a Bus
2. Manually Connecting Buslines
3. Automatically Creating New Buslines
4. Automatically Connecting to Existing Buslines
Placing a Bus
发布者：admin，转转请注明出处：http://www.yc00.com/news/1712494635a2069801.html
评论列表（0条）